MODEL 3 SERVICE MANUAL
GENERAL INFORMATION
- INTRODUCTION
- BEST PRACTICES
- CHARGING
  - GENERAL
- TECHNICAL DATA
  - MOTORS
  - SUSPENSION
  - WHEEL ALIGNMENT
  - BRAKES
  - WHEELS
  - TIRE PRESSURES
  - ELECTRICAL
- IDENTIFICATION NUMBERS
- FLUIDS AND CAPACITIES
00 - INSPECTION AND SERVICE
- 0001 - MAINTENANCE SERVICE
  - MAINTENANCE SERVICE AND INTERVALS
10 - BODY
- 1000 - VEHICLE LIFTING
  - RAISE VEHICLE - 2 POST LIFT
  - RAISE VEHICLE - 4 POST LIFT
- 1001 - BUMPER / FASCIA
- 1010 - BODY PANELS
- 1020 - WINDSHIELD AND BODY GLASS
- 1030 - PAINT
  - PAINT DEFECT RECTIFICATION
11 - CLOSURES
- 1133 - CLOSURE ASSIST MECHANISMS AND HINGES
- 1135 - LATCHES STRIKERS AND PINCH SENSORS
- 1145 - EXTERIOR DOOR HANDLES
- 1150 - DOOR GLASS AND REGULATORS
- 1170 - SEALS BODY CLOSURES
12 - EXTERIOR FITTINGS
- 1201 - WHEEL ARCH LINERS
  - WHEEL ARCH LINER - FRONT - LH (REMOVE AND REPLACE)
  - WHEEL ARCH LINER - REAR - LH (REMOVE AND REPLACE)
- 1203 - UNDERTRAY AND DIFFUSER
- 1205 - BADGES AND FILMS
- 1207 - LICENSE PLATE MOUNTINGS
- 1209 - EXTERIOR MIRRORS
- 1220 - EXTERIOR TRIM
- 1222 - SPOILER
  - SPOILER - REAR (RETROFIT USING JIG)
  - SPOILER - REAR (RETROFIT USING TAPE)
- 1225 - UNDERHOOD TRIM
13 - SEATS
- 1301 - FRONT SEAT TRACKS AND MOTORS
- 1304 - FRONT SEAT ASSEMBLIES AND HARDWARE
- 1305 - 2ND ROW SEAT ASSEMBLIES AND HARDWARE
- 1307 - FRONT SEAT COVERS PADS AND TRIMS
- 1308 - 2ND ROW SEAT COVERS PADS AND TRIMS
  - COVER - SEAT BACK - 2ND ROW SEAT - RH (REMOVE AND REPLACE)
  - CUP HOLDER - 2ND ROW (REMOVE AND REPLACE)
14 - INSTRUMENT PANEL
- 1405 - INSTRUMENT PANEL
15 - INTERIOR TRIM
- 1505 - INTERIOR MIRROR AND SUN VISORS
- 1511 - TRUNK TRIM
  - GARNISH - TRUNK (REMOVE AND REPLACE)
  - TRIM - LID - TRUNK (REMOVE AND REPLACE)
- 1513 - DOOR TRIM
- 1518 - PILLAR AND SILL TRIM
- 1519 - CENTER CONSOLE
- 1520 - HEADLINER
- 1524 - LUGGAGE COMPARTMENT TRIM
- 1530 - CARPETING AND MATS
16 - BATTERY SYSTEM
- 1601 - HV BATTERY ASSEMBLY
- 1610 - HV BATTERY ENCLOSURE
- 1620 - HV BATTERY COOLING SYSTEM
- 1630 - HV BATTERY ELECTRICAL COMPONENTS
17 - ELECTRICAL
- 1701 - 12V BATTERY AND FUSES
- 1710 - HARNESSES
- 1715 - ELECTRONIC CONTROL MODULES
- 1720 - RADAR SENSORS
  - SENSOR - RADAR - FRONT (CALIBRATION)
  - SENSOR - RADAR - FRONT (REMOVE AND REPLACE)
- 1723 - FRONT CAMERAS
  - CAMERA - FORWARD FACING (REMOVE AND REPLACE)
  - CAMERA - FORWARD FACING (TARGET CALIBRATION)
- 1724 - INTERIOR CAMERA
  - CAMERA - OCCUPANT (REMOVE AND REPLACE)
- 1725 - REAR CAMERAS
  - CAMERA - REAR FACING (REMOVE AND REPLACE)
- 1727 - PARKING SENSORS
  - SENSOR - PARKING DISTANCE - FRONT - EACH (REMOVE AND REPLACE)
  - SENSOR - PARKING DISTANCE - REAR - EACH (REMOVE AND REPLACE)
- 1730 - INTERIOR SWITCHES
- 1735 - INTERIOR LIGHTING
  - PUDDLE LIGHT - FRONT DOOR - LH (REMOVE AND REPLACE)
  - PUDDLE LIGHT - REAR DOOR - LH (REMOVE AND REPLACE)
- 1740 - EXTERIOR LIGHTS
- 1745 - KEYLESS ENTRY AND SECURITY
- 1750 - WIPERS AND WASHERS
- 1753 - HORNS
  - HORN - HIGH TONE (REMOVE AND REPLACE)
  - HORN - LOW TONE (REMOVE AND REPLACE)
- 1754 - PEDESTRIAN WARNING SPEAKER
  - SPEAKER - PEDESTRIAN WARNING (REMOVE AND REPLACE)
- 1755 - ACCELERATOR PEDAL
  - ACCELERATOR (REMOVE AND REPLACE)
18 - THERMAL MANAGEMENT
- 1810 - CABIN HVAC
- 1820 - REFRIGERANT SYSTEM
- 1830 - COOLING SYSTEM
- 1850 - AIR DISTRIBUTION
  - ACTIVE GRILLE SHUTTER (REMOVE AND REPLACE)
20 - SAFETY AND RESTRAINT
- 2001 - AIRBAGS
- 2005 - SEATBELTS
- 2010 - PRETENSIONERS
  - PRETENSIONER - OUTBOARD LAP - 1ST ROW - LH (REMOVE AND REPLACE)
- 2020 - SENSORS
21 - INFOTAINMENT
- 2105 - TOUCHSCREEN
  - TOUCHSCREEN (REMOVE AND REPLACE)
- 2115 - CAR COMPUTER
- 2121 - AUDIO SYSTEM - SPEAKERS SUBWOOFER AMPLIFIER
- 2125 - AUDIO SYSTEM - BLUETOOTH
  - MICROPHONE - BLUETOOTH (REMOVE AND REPLACE)
- 2126 - AUDIO SYSTEM - USB MEDIA PORT
  - USB HUB - CENTER CONSOLE - FRONT (REMOVE AND REPLACE)
  - USB HUB - CENTER CONSOLE - REAR (REMOVE AND REPLACE)
- 2130 - ANTENNA - FM HD RADIO
  - AMPLIFIER - ANTENNA - FM (REMOVE AND REPLACE)
  - TUNER - FM / HD (REMOVE AND REPLACE)
- 2131 - ANTENNA - SATELLITE RADIO
- 2132 - ANTENNA - GPS
  - ANTENNA - GPS (REMOVE AND REPLACE)
- 2133 - ANTENNA - WI-FI
  - ANTENNA - WI-FI (REMOVE AND REPLACE)
30 - CHASSIS
- 3001 - CHASSIS AND SUBFRAMES
31 - SUSPENSION
- 3100 - ADJUSTMENT
  - FOUR WHEEL ALIGNMENT (CHECK)
  - FOUR WHEEL ALIGNMENT (CHECK AND ADJUST)
- 3101 - FRONT SUSPENSION (INCLUDING HUBS)
- 3103 - REAR SUSPENSION (INCLUDING HUBS)
- 3115 - COIL SUSPENSION SYSTEM
32 - STEERING
- 3201 - STEERING RACK AND LOWER COLUMN
- 3205 - UPPER COLUMN STEERING WHEEL STEERING LOCK
33 - BRAKES
- TORQUE SPECIFICATIONS - BRAKES
- 3301 - BRAKE DISCS AND CALIPERS
- 3303 - BRAKE PIPES AND HOSES
- 3305 - PARKING BRAKE
  - PARKING BRAKE - CALIPER - REAR - LH (RELEASE)
- 3310 - ABS TRACTION AND STABILITY CONTROL
- 3320 - BRAKE BOOSTER
  - BOOSTER - BRAKE - ELECTROMECHANICAL (LHD) (REMOVE AND REPLACE)
  - MASTER CYLINDER AND RESERVOIR ASSEMBLY (REMOVE AND REPLACE)
- 3325 - BRAKE PEDAL
  - BRAKE PEDAL (REMOVE AND REPLACE)
  - SWITCH - BRAKE LIGHT (REMOVE AND REPLACE)
34 - WHEEL AND TIRES
- 3401 - WHEELS
  - CAP - WHEEL (REMOVE AND REPLACE)
  - WHEEL (REMOVE AND INSTALL)
- 3402 - TIRES
- 3404 - TIRE PRESSURE MONITORING SYSTEM (TPMS)
39 - FRONT DRIVE UNIT
- 3901 - FRONT DRIVE UNIT ASSEMBLY
- 3920 - FRONT DRIVE INVERTER
  - HOSE - INVERTER INLET - FRONT DRIVE UNIT (REMOVE AND REPLACE)
  - HOSE - INVERTER TO HEAT EXCHANGER - FRONT DRIVE UNIT (REMOVE AND REPLACE)
- 3930 - FRONT GEARBOX AND HALFSHAFTS
40 - REAR DRIVE UNIT
- 4001 - REAR DRIVE UNIT ASSEMBLY
- 4010 - REAR MOTOR
  - MOTOR ASSEMBLY - REAR (REMOVE AND REPLACE)
  - SENSOR - REAR MOTOR - SPEED (REMOVE AND REPLACE)
- 4020 - REAR DRIVE INVERTER
- 4030 - REAR GEARBOX AND HALFSHAFTS
44 - HIGH VOLTAGE SYSTEM
- 4401 - CHARGE SYSTEM INLET
- 4450 - HV HARNESSES
50 - EXTERNAL CHARGING CONNECTORS
- 5001 - MOBILE CONNECTOR
  - FIRMWARE UPDATE - CHADEMO CHARGING ADAPTER

Seal - Hood (Remove and Replace)

Correction code 1170180211701802

Remove

Open the hood.
Release the seal from the underhood storage unit, and then remove the seal from the underhood storage unit.

		1	Open the hood.
		2	Release the seal from the underhood storage unit, and then remove the seal from the underhood storage unit.

Install

Installation procedure is the reverse of removal, except for the following:

During installation, align the line from the seal to the line from the underhood storage unit.