Cooling System (Partial Refill and Bleed)
Correction code 1830000018300000
DRAFT
from-cad
Warning:
This procedure was derived from pre-production computer models, and might not reflect the real-world situation. Warnings and cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components.
Do not redistribute this content. Provide corrections and feedback to servicemanualfeedback@tesla.com.
Procedure
- Use Toolbox to set the cooling system to fill mode.
- Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace).
- Remove the coolant reservoir cap from the superbottle.
- Fill coolant to the proper level.
- Use Toolbox to run the coolant purge routine.
- Use Toolbox to run the thermal system test.
- Install the coolant reservoir cap onto the superbottle.
- Install the cabin intake duct. See Duct - Cabin Intake (Remove and Replace).
| 1 | Use Toolbox to set the cooling system to fill mode. |
| 2 | Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace). |
| 3 | Remove the coolant reservoir cap from the superbottle. |
| 4 | Fill coolant to the proper level. |
| 5 | Use Toolbox to run the coolant purge routine. |
| 6 | Use Toolbox to run the thermal system test. |
| 7 | Install the coolant reservoir cap onto the superbottle. |
| 8 | Install the cabin intake duct. See Duct - Cabin Intake (Remove and Replace). |